Guide to Using 'Hoseless' or Tubeless' Pole Hose Setups
- 28 Jun 2021
Here is an explanatory guide and a DIY Guide to converting our poles to a hoseless or tubeless setup
Here is an explanatory guide and a DIY Guide to converting our poles to a hoseless or tubeless setup
Maintenance of Poles
A guide to measuring and identifying BSP thread sizes
Please note the following glossary is a work in progress. If you have any term suggestions you would like including in the glossary or questions about the glossary please email us on - [email protected]
BACKPACK USE AND BATTERY CHARGING INSTRUCTIONS
To use the variable flow controller on the V3 Backpack, push the on/off switch to the “I” position and then turn on the unit using the flow control silver dial until the desired flow rate is reached. When desired flow rate is set, you can then switch on and off to this speed using just the on/off switch. For full flow rate push the switch to the “II” setting
The battery comes fully charged as standard. However, it is recommended that you charge the battery again until the green light on the charger illuminates. Charger will show RED led whilst charging and when battery is less than full.
To read the voltmeter: Turn the pump switch to the II setting - when all three lights show, this indicates the backpack is fully charged; when just the red and yellow lights show, this indicates the backpack needs to be re-charged soon; when the red light only shows it indicates the backpack must be recharged immediately. Failure to do so and continuing to use the backpack in this battery state could damage the battery and shorten its lifespan.