Backpack Pump - V3
£22.50
Plus 20% VAT
In stock
Replacement pump for the V3 Gardiner Pure Water Backpack
- 2200rpm
- 12v
Replacement pump for the V3 Gardiner Pure Water Backpack
- 2200rpm
- 12v
Please see 'Technical Info' tab for instructions on fitting this to an older V1 & V2 backpack
6 Month warranty - when fitted to a Gardiner V3 backpack
This pump is a direct replacement for the pump fitted to the V3 Backpack.
Please note, this item is only warrantied for use in a Gardiner V3 backpack.
It can also be fitted to the older V1 & V2 backpack with the use of a few extra parts - please see below for instructions on how to use this pump in a V1 & V2 backpack:
Extra parts needed to fit this item to a V1 & V2 backpack:
- 2x Twist-On Wiring Connector
- 1x Inline Bore Adapters in 6mm to 8mm size
- 3x Jubilee Clips - 1x in 8-12mm and 2x in 12-20mm
- 1x Short length (about 8cm) of 8mm ID hose - such as the backpack orange hose
Instructions for fitting this item to a V1 & V2 backpack:
- Remove the old pump and chop through the feed wires
- Attach the short length of 8mm ID Hose to the inlet on the new pump and fix with a jubilee clip
- Attach the inline bore adapter to this 8mm ID hose and attach with a jubilee clip
- Cut off the yellow end connector and insert from the hose from the tank to the pump
- Attach the smaller end of the inline bore adapter to this hose from the tank
- Take the backpack hose (clear hose from the outside of the backpack), cut off the screw nut and the insert from the hose
- Feed this end of the hose through the hole in the side of the backpack and connect to the outlet on the pump and fix with a jubilee clip
- Mount the pump back in the correct position in the base of the backpack and use the two mounting feet to fix it to the plastic base
- Using the crimp 3M connectors connect the feed wires to the pump wires - strip about 1cm of the cable sheath off each wire before inserting in the connector and crimping down
- Re-assemble the backpack
Product Questions
Be The First To Review This Product